Seco-Larm Enforcer Polarized Reflective Beam Sensor, 33 Ft. (E-931-S33PRGQ)

Description

Monitor your garage, gate, driveway or doorway with the Seco-Larm Enforcer Polarized Reflective Beam Sensor (33'). This weatherproof sensor triggers an alarm in a connected security system when its infrared (IR) beam is broken. It also provides reliable detection of shiny objects (chrome bumper or other metallic material on a vehicle) that could be missed by a non-polarized sensor. The 3-1/4-inch round reflector can be installed discreetly on a wall or other flat surface. It provides a large sensing area for wide entryways, as well as easier alignment during installation.
Detects shiny objects (chrome bumper or other metallic material on a vehicle) that are typically missed by a non-polarized sensor
Up to 33-foot sensing range (sensor to reflector)
Suitable for indoor or outdoor use
Weatherproof with anti-condensation housing
Mounting hardware included
Wiring Information
Polarity does not matter for the power input
Connect the N.C. tamper terminal to the tamper circuit of your alarm control panel
Contents
Sensor
Reflector
Mounting Bracket
Sensor Hood
Reflector Hood
(4) Cover Screws
(2) Mounting Screws
Reflector Mounting Screw
Rubber Ring
Cable Connector
Manual
Removable Terminal Block
10kΩ Resistor
NOTE: Requires a security system or alarm device to alert you when activated.
Technical Details
Manufacturer Part #:
E-931-S33PRGQ
UPC:
676544017301
Sensing Range:
33ft (10m)
Operating Voltage:
12-30V DC/AC 60Hz, 100mA
Current Draw:
Standby: 55mA@12VDC
Active: 40mA@12VDC
Response Time:
10ms (max.)
Light Source:
IR LED/Wavelength 740nm
LED:
Solid Green: Good beam signal, properly aligned
Alternating Flash: Poor beam signal
Solid Red: No beam signal, triggered
Trigger Output:
SPDT Relay output (NO/NC/COM)
Switching Capacity:
0.5A at 30VAC/VDC
Tamper Switch:
N.C., 500mA at 30VAC/VDC
IP Rating:
IP55
Operating Temperature:
-4°F to 131° F (-20° to 55° C)
Certifications:
CE, RoHS
Warranty:
1 Year